MFZ Marantec Ovitor Door Control CS 310 Large Housing 400V/3PH with DIN-rail and Power Supply

For use with the control unit CS 310/ 320, timeswitch for application in eg. Underground parking facilities, disrupts the automatic timer-to-close function during individually programmed timeslots

Installation in CS310/ 320 standard- and combi-housing lid (delivery without lid), for shutdown of the drive system in an emergency

Installation in CS310/ 320 standard- and combi-housing lid (delivery without lid), ON/ OFF Switch for control voltage

Installation in CS310/ 320 standard- and combi-housing lid (delivery without lid), ON/ OFF Switch for power supply voltage

Selector to switch operation mode between Summer and Winter operation, for installation in CS310/ 320 standard- and combi-housing lid (delivery without lid)

Extension Module for door control units CS 310 und CS 255 AC, supply cable 500mm, connection cable 200mm, DIN-rail-mount, traffic control with connectors for red/ green signal lights and Open/ Close pushbuttons

Coil cord for doors, EstTPU/PP, black, cable configuration: fine-stranded 5x0,25mm²,  Lif9Y11Y, dimensions: left end = 300mm, coil length = 900mm, right end = 2000mm, max. extension length 3,5m   Description: The coil cord was developed especially for use on doors to connect the sensors and switches on the door leaf. Properties: Due to the 800mm-long spiral block, the coil cable can be extended to a length of up to 3.5m. The 5-core cable installation and a 0.25mm² conductor cross-section means the helical cable has enough strands for e.g. the safety edge and slack-rope switches Sheath and core insulation made of high-grade materials Can be installed universally on doors from various manufacturers

Electrical box with status LED, 90 x 48,5 x 40mm, with 1x M16 cable gland, 1x blind plug and 1x M16 cable gland with bend protectionDescription:The Fraba Vitector small junction box is distinguished by its compact design. The connection circuit board ensures the cables can be easily connected to the door.Further characteristics:90 x 48,5 x 40mm1 x M16 open in the ground1 x pre-shaped for the ground1 x M16 open in the lidIncludes 1 x M16 cable gland, 1 blind plug, and 1 M16 with bend protection

Electrical box with status LED, 40 x 136 x 56 mm, incl. 3x M16 cable glands, 1x M16 cable gland with bend protection and 4x M16 lock nutDescription:The Fraba Vitector large junction box is useful wherever lots of space is needed for cabling from sensors, photo-eye switches, pass-door switches, slack-rope switches, etc. The connection circuit board ensures the cables can be easily connected to the door.Further characteristics:Dimensions: 40 x 136 x 56 mmTransparent coverPre-punched cable entries 5xM16 in the housing, 1xM16 in the lidIncludes 3xM16 cable glands, 1x bend protector and 4 x locknuts

Set Transmitter (Tx) and Receiver (Rx) for Optical Sensing Edge OSE, PVC-cable, cable length 10,5m/0,5m, without plugsDescription:The FRABA VITECTOR OSE-S 6502 sensor set consists of a transmitter (Tx) and a receiver (Rx) for optical sensing edges. For an electrical connection, the sensors are equipped with a top-quality PVC Cable (length: transmitter - 10.5 m and receiver - 0.5m). The sensors are based on the original FRABA OSE technology and provide the well-known OSE-signal, which is implemented in many controllers.Warning:The 4-digit sequence of numbers used on the displays shows the sensor's manufacture date in week / year format. For example, 0118 shows the sensor was produced in the first calendar week (01) of 2018.

Motor cable for STA drives, length 5m, also compatible to drive series KD 05, MTZ 05, MDF 05 und MWF 05

Industrial Door Drive for counter sectional doors, output torque 100 Nm, output speed 30 rpm, hollow shaft diameter 25,4mm, digital limit switch, with emergency hand chain for manual operation, with digital limit switch / absolute rotary encoder AWG, limit switch range 20 rotations max.Description:The drives of the STA/STAW series are ideally designed for counter-balanced sectional doors. This is guaranteed by a special gear with a motor developed to ensure maximum strength in the smallest space. Therefore, the drive is extremely compact, and its casing is very slim.Features:Aluminium die-cast casingRolling worm shaftDual worm shaft bearingThermal protection built into the motor windings230 / 400V / 50 Hz / 3~, custom solutions on requestPlug-in connectors

Industrial Door Drive for counter sectional doors, output torque 110 Nm, output speed 24 rpm, hollow shaft diameter 25,4mm, digital limit switch, with emergency hand chain for manual operation, with digital limit switch / absolute rotary encoder AWG, limit switch range 20 rotations max.Description:The drives of the STA/STAW series are ideally designed for counter-balanced sectional doors. This is guaranteed by a special gear with a motor developed to ensure maximum strength in the smallest space. Therefore, the drive is extremely compact, and its casing is very slim.Features:Aluminium die-cast casingRolling worm shaftDual worm shaft bearingThermal protection built into the motor windings230 / 400V / 50 Hz / 3~, custom solutions on requestPlug-in connectors

Industrial Door Drive for counter sectional doors, output torque 120 Nm, output speed 19 rpm, hollow shaft diameter 25,4mm, digital limit switch, with emergency hand chain for manual operation, with digital limit switch / absolute rotary encoder AWG, limit switch range 20 rotations max.Description:The drives of the STA/STAW series are ideally designed for counter-balanced sectional doors. This is guaranteed by a special gear with a motor developed to ensure maximum strength in the smallest space. Therefore, the drive is extremely compact, and its casing is very slim.Features:Aluminium die-cast casingRolling worm shaftDual worm shaft bearingThermal protection built into the motor windings230 / 400V / 50 Hz / 3~, custom solutions on requestPlug-in connectors

Industrial Door Drive for counter sectional doors, output torque 130 Nm, output speed 15 rpm, hollow shaft diameter 25,4mm, digital limit switch, with emergency hand chain for manual operation, with digital limit switch / absolute rotary encoder AWG, limit switch range 20 rotations max.Description:The drives of the STA/STAW series are ideally designed for counter-balanced sectional doors. This is guaranteed by a special gear with a motor developed to ensure maximum strength in the smallest space. Therefore, the drive is extremely compact, and its casing is very slim.Features:Aluminium die-cast casingRolling worm shaftDual worm shaft bearingThermal protection built into the motor windings230 / 400V / 50 Hz / 3~, custom solutions on requestPlug-in connectors

Industrial Door Drive for counter sectional doors, output torque 110 Nm, output speed 19 rpm, hollow shaft diameter 25,4mm, digital limit switch, with emergency hand chain for manual operation, with digital limit switch / absolute rotary encoder AWG, limit switch range 20 rotations max.Description:The drives of the STA/STAW series are ideally designed for counter-balanced sectional doors. This is guaranteed by a special gear with a motor developed to ensure maximum strength in the smallest space. Therefore, the drive is extremely compact, and its casing is very slim.Features:Aluminium die-cast casingRolling worm shaftDual worm shaft bearingThermal protection built into the motor windings230 / 400V / 50 Hz / 3~, custom solutions on requestPlug-in connectors

Industrial Door Drive for counter sectional doors, output torque 100 Nm, output speed 24 rpm, hollow shaft diameter 25,4mm, digital limit switch, with emergency hand chain for manual operation, with digital limit switch / absolute rotary encoder AWG, limit switch range 20 rotations max.Description:The drives of the STA/STAW series are ideally designed for counter-balanced sectional doors. This is guaranteed by a special gear with a motor developed to ensure maximum strength in the smallest space. Therefore, the drive is extremely compact, and its casing is very slim.Features:Aluminium die-cast casingRolling worm shaftDual worm shaft bearingThermal protection built into the motor windings230 / 400V / 50 Hz / 3~, custom solutions on requestPlug-in connectors

Installation in CS310/ 320 standard- and combi-housing lid (delivery without lid), for shutdown of the drive system in an emergency

Installation in CS310/ 320 standard- and combi-housing lid (delivery without lid), ON/ OFF Switch for control voltage

Installation in CS310/ 320 standard- and combi-housing lid (delivery without lid), ON/ OFF Switch for power supply voltage

Coil cord for doors, EstTPU/PP, black, cable configuration: fine-stranded 5x0,25mm²,  Lif9Y11Y, dimensions: left end = 300mm, coil length = 900mm, right end = 2000mm, max. extension length 3,5m   Description: The coil cord was developed especially for use on doors to connect the sensors and switches on the door leaf. Properties: Due to the 800mm-long spiral block, the coil cable can be extended to a length of up to 3.5m. The 5-core cable installation and a 0.25mm² conductor cross-section means the helical cable has enough strands for e.g. the safety edge and slack-rope switches Sheath and core insulation made of high-grade materials Can be installed universally on doors from various manufacturers

Radio Receiver by MFZ Marantec Ovitor for the door control unit CS 310, pluggable version, frequency 868 MHz

Remote Digital 382 by MFZ Marantec Ovitor, 2-channel, unidirectional, frequency 868 MHz, incl. battery and holder   Product details: The Marantec Digital 382 remote control with 868 MHz multi-bit technology offers a simple and reliable solution for controlling Marantec and compatible third-party operators. The remote control has two radio channels with which you can operate up to two door operators. It is ideal for older Garage door openers from the Marantec Comfort range as well as for industrial door control units such as the CS 255, CS 300, CS 310 and CS 320 with radio module.Scope of delivery:- 1 x Marantec Digital 382 remote control 868 MHz - 1 x key ring holder - 1 x remote control holder - 1 x retaining clip for the sun visor - 1 x CR 2032 batteryThanks to its compact design, the Marantec Digital 382 fits comfortably on a key ring or in the car, making it particularly practical to use. It can be easily programmed and connected to various drives.Technical data:- Radio standard: 868.3 MHz multi-bit, unidirectional- Buttons: 2 radio channels- Compatible with Marantec drives (e.g. Comfort 260, 270, 280, 360, 380, 260 accu)  

Door control unit for MFZ/Ovitor drives with digital limit switch AWG or mechanical limit switch, in Large PVC-housingDescription:The CS 320 door control unit from MFZ / Marantec / Ovitor is an automatic comfort control unit for use in industrial doors. It is optimally suited for use in sectional doors, roller shutters and sliding gates and can be used with MFZ / Marantec / Ovitor drives with mechanical limit switch or absolute rotary encoder. For application with drives without a frequency converter, or doors on which fewer accessories are installed, the manufacturer also offers the somewhat more economical CS 320 Lite variant (see "Alternative products").Characteristics of the CS 320:- Automatic comfort controller for industrial doors.- EN 12453:2017 certified- Flexibility due to various connection possibilities- Additional modules available for connection through MSBUS - Variable frequency drive control possible via the FI function on compatible drives- Pluggable wireless system- LCD Display as plain text indicator - Illuminated lid keyboard - Connection possibilities with various sensors- Compatible with the existing accessories programme of the CS 310